Details
The MW853UST+ 3200-Lumen WXGA Ultra-Short Throw DLP Projector from BenQ features a 0.43:1 throw ratio, which is ideal for classroom and other applications where the projector is to be mounted very close to the screen • single lamp provides 3200 ANSI lumens brightness in Normal Mode, and a single-chip DLP imaging device renders a 1280 x 800 (WXGA) resolution, 16:10 aspect ratio image • Through scaling the projector can also support a range of non-native resolutions, up to Full HD (1920 x 1080) for video and UXGA (1600 x 1200) for computer sources • special USB type port the MW853UST+can interface with the PointWrite interactive learning system, the hardware for which is available separately • With a 0.43:1 throw ratio it is possible to render a 80"-wide (100"-diagonal) image with the projector mounted 34" away from the screen • Turn any surface into an interactive whiteboard that you can draw on with PointWrite pens or just your fingers • Seamlessly merge the image from two projectors to create an extra large virtual workspace • Up to four fingers/pens can be used at once • For faster setup, auto calibration takes as litter as one second (depending on your computer) • Up to 0.016-second response time when writing • single lamp provides 3000 lumens of brightness in Normal mode, and is estimated to last 4000 hours (up to 7000 hours in the lower brightness SmartEco Mode) • This is considered a widescreen format, and comes very close to the 16:9 standard of HDTV • Uses a combination of a chip covered in millions of micro-mirrors and a color wheel to produce an image • Allows the installation of the Touch Module (PT01) required to use the PointWrite system, which is available separately • Allows teachers or presenters to blank the projection screen whenever they need to direct focus back on them and not the image - or simply to save power when the projector is not in use. • Features DLP technology to support 3D functionality, allowing you to bring an immersive learning experience to students with a simple preparation of separately available 3D glasses and 3D content • Enables up to six-color processing by incorporating the secondary colors Yellow, Cyan, and Magenta along with primary Red, Blue, and Green to help provide more accurate color reproduction • An RS-232 port means the projector can be controlled from a computer running custom software or via automation system such as Crestron • Two USB ports are included. A USB 2.0 type B female for connecting to a computer to install firmware update • A fan-based cooling system ensures the lamp stays within a safe operation temperature range • The wall mount features an installation chart and a measuring ruler to help you find the most suitable projector-screen alignment and image position for your classroom • Picture Modes: Dynamic, Presentation, sRGB, Cinema, 3D, User 1, User 2
